Huawei aluminum factory
Standards : ASTM B209 / ASME SB209
Thickness : 0.2-50
Width : 100-2600
Length : 500-10000
Temper : O,H12,H14,H16,H18,H19,H22,H24
ASTM B209 / ASME SB209 - Standard Specification for Aluminum and Aluminum-Alloy Seamless Pipe and Seamless Extruded plates
ASTM B345 / ASME S345 - Standard Specification for Aluminum and Aluminum-Alloy Seamless Pipe and Seamless Extruded Pipe for Gas and Oil Transmission and Distribution Piping Systems
ASTM B429 / ASME SB429 - Standard Specification for Aluminum-Alloy Extruded Structural Pipe and Tube
EN AW-AlMg1SiCu - Standard Specification for Aluminum and Aluminum-Alloy Round Pipe
ISO AlMg1SiCu - Standard Specification for Aluminum and Aluminum-Alloy Cold / Hot Rolled Piping




Manufacturing Aluminum Foil, Types of Aluminum Alloy
Aluminum foil products are commonplace in the modern world – nearly everyone has a roll in their kitchen for cooking applications. Manufacturing aluminum foil was is a process that dates back to the early 20th century when small quantities of foil were produced by hammering. This method of manufacturing aluminum sheet foil was labor-intensive and .
Contact Us

Cold rolling the aluminum sheet - Aluminium Guide
Coiling the aluminum sheet into the bay. Length list, who wound up in a bay, It depends on the diameter of the bay and the sheet thickness. The coil with an inner radius 255 mm and an outer radius 1220 mm can accommodate 760 layers of sheet, rolled to a typical thickness 1,25 mm. One such bay comprise aluminum sheet longer than three kilometers.
Contact Us
Aluminum Rolling Mills Explained | HARBOR
2 · 2. ALUMINUM SHEETS. Shaping an aluminum sheet begins with the same process as an aluminum plate. Aluminum plates pass through a continuous rolling mill to further reduce plate thickness. The final step for .
Contact Us

Aluminium for Future Generations – Rolling
The process relies on the heat transfer between the solidifying (& compressed) melt and the roll surfaces to solidify the aluminium which results in very high cooling rates. Because of this, conventional twin roll .
Contact Us






